Controller Vibration Test

Use this controller vibration test online to drive one rumble motor at a time, at the strength and length you choose. A motor that stays silent shows up in seconds.

Waiting for a controller. Press one of its buttons.

Strong motorIdle
Grip
Left
Feel
Low, deep rumble
Output
0%
Weak motorIdle
Grip
Right
Feel
Light, fast buzz
Output
0%
Motor
Pattern

How to run the controller vibration test

  1. Pick a motor. With your controller connected, choose Both, Strong or Weak in the panel above.
  2. Set strength and length. Begin at 100% for two seconds. Lower the strength afterwards to find the weakest setting you still feel.
  3. Press Start and hold on. Keep both hands on the grips. A motor is easier to feel than to hear.

Run the vibration test once for each motor before you judge them. If Start stays grey, the page has not seen your controller yet: the controller tester page lists what to check.

Strong motor, weak motor: what you should feel

  • Strong motor, left grip A heavy weight that turns slowly. It gives a low, deep rumble in your left palm.
  • Weak motor, right grip A small weight that turns fast. It gives a light, quick buzz in your right palm.

The controller vibration test runs the two one at a time, so you can compare them. A grip that stays still at 100% has a dead motor or a loose wire. Two grips that feel alike are not a fault: some controllers, mostly cheaper ones, have a single motor or two identical ones, and they still pass a controller rumble test.

Controller not vibrating?

Check these from top to bottom.

  1. Check the browser. The first row of the table below says whether this browser can send vibration to your controller.
  2. Use a cable. Vibration can drop out over Bluetooth even when every button works. USB rules that out.
  3. Check the game. If the motors run here and stay still in a game, turn vibration on in that game's settings or in Steam.
  4. Charge it. Some wireless controllers cut vibration when the battery runs low.
  5. Suspect the motor. Wired, charged and still silent at 100% in a browser that supports it? The motor or its solder joint has failed.

A gamepad vibration test can only send the command. It cannot sense whether the motor turned, so your hands are the judge.

Which browsers and controllers can vibrate

BrowserVibrationNotes
This browserPlug in a controller to seeLive result for the controller in your hands
Chrome and EdgeYesEach motor on its own, on computers
Safari on MacYesFrom version 16.4
Chrome on AndroidVariesDepends on the phone and the controller
FirefoxNoWebsites cannot drive the two motors separately
Safari on iPhone and iPadNoNot available

Only the first row is measured on your device. The other rows follow what each browser publishes, so a vibration test in Chrome or Edge on a computer is the safest choice: both send rumble to Xbox, PlayStation and Switch Pro controllers.

More controller tests

Frequently asked questions

Why does only one side of my controller vibrate?

Each grip has its own motor. Run Strong, then Weak. If one stays still at 100%, that motor has failed. If both run here, the game is only using one of them, which is normal for light effects.

Can a controller vibration test damage my controller?

No. The page sends the same command a game sends, and every run ends by itself after five seconds at most.

Can I test the trigger motors here?

Not on this page. The impulse triggers on Xbox controllers have two more motors of their own, and the Xbox controller tester runs those.

Can a phone make my controller vibrate?

Sometimes. Chrome on Android can with some controllers. Safari on iPhone reads buttons and sticks and leaves the motors alone.